Home > Remote Start > Car Starter Remote Not Working

Car Starter Remote Not Working

Contents

September 29, 2013 By staff As the weather gets colder, we get a lot of phone calls from our remote car starter clients (There are over 3000 of them!). What could be the problem and how can I fix it. Reply Mitch says February 29, 2012 at 10:25 pm Tiffany, VERY tough call.. The dealer wasn't aware of it and I discovered it by accident. Source

It is possible that the manufacturer would be able to walk you through the reprogramming procedure. I have replaced the batteries in both remotes still nothing . It's worked like a charm for all of these years. It can be an intermittent issue in the starter or another part of the vehicle and that will be very difficult to nail down..

Remote Starter Clicks But Wont Start

We have not had any service done on the car. Thanks for the guide, most useful tool you put together to help out folks! my key is not a transponder, just plain old key. Now that is cold again I decided to look into it.

Reply Mitch says February 14, 2012 at 1:00 pm Glenn, Tough one… I'm assuming that the power door lock work when you press the switch on the door? Hakkında Basın Telif hakkı İçerik Oluşturucular Reklam Verme Geliştiriciler +YouTube Şartlar Gizlilik Politika ve Güvenlik Geri bildirim gönder Yeni bir şeyler deneyin! I'll bet its a simple fix. Compustar Remote Start Reset Hood pin and brake wire are confused and hooked up improperly.

When I hit buttons on remote my hazard lights flash 1 or 2 times, but car will not start. Remote Start Wont Turn Over Reply Ariel says February 20, 2012 at 9:18 pm Hi mitch, my remote starter was included With The Car, wich i bougth ‘as is' So I have no manual and The Hood Pin Has Broken or Failed This is what a properly installed hood pin looks like.

Q4: When you press start button, the ignition comes on but the starter does not crank.

All I can say it just stopped working for some reason. Remote Start Not Working Check Engine Light On our more recent remotes the front and back halves of the remote case snap together and can also be separated by gently prying the two halves apart with a flat-blade Q4: Press any button on remote and the trunk pops: A: 1. Check to be sure your hood pin is in working order if equipped.

Remote Start Wont Turn Over

If this scenario sounds like you, call us, and we will set you up for a quick diagnostic appointment and get you back to being warm and toasty. Reply Russ says November 5, 2012 at 1:54 pm Bruce were you able to determine the problem for this? Remote Starter Clicks But Wont Start What do I do now”? Reprogram Remote Starter We couldnt get any lights blinking to tell us what was going on.

Any ideas why this is happening and what I can do to correct it? this contact form Reply Dave says November 14, 2012 at 9:24 am interesting one here…2way compustar remote. Thank you. Reply Debbie Frezza says February 2, 2012 at 3:39 pm My starter remote only has one button. Remote Car Starter Problems Battery

The mobile electronics industry switches into “starter … [Read More...]Product Spotlight: Compustar RF-2W902Here at Perfectionist Auto Sound and Security, we are the experts in remote start systems and we are always I could be way off on this one… Unfortunately, I have to recommend that you re-visit you dealer with this issue. If you pushed the button a few times it would finally activate to start and the same with the door locks you would hit the button like ten times then it http://clearduplicatefiles.com/remote-start/compustar-remote-starter-not-working.html Take the vehicle back to where it was purchased and installed.

Reply C Prosser says December 4, 2011 at 6:15 pm I have a Compustar 2 way remote starter in my 2007 Matrix, just installed in April 2011. Autostart Remote Starter Troubleshooting Note that, in some cases, a tilt switch is used in lieu of a hood pin. I noticed that once I pushed the autostart button my park lights did not come and the LED light in the car which controls the autostart was on as a steady

Before the parking lights came on, then go off while starting, then come back on when car starts.

I am pretty sure the battery is up to snuff - car starts very well when it does. Reply Bruce says March 17, 2012 at 6:43 pm Mitch, I have 98 Silverado with a Valet 551R that was installed in 99. My girlfriends car's starter system manufatcurer however does not put a trouble shooting guide in their manual, and doesnt tell you what the lights time the number of blinks means, she Viper Remote Start Not Working Take care.

Yükleniyor... Its on a Chrysler 300c if that helps it unlocks doors locks and trunk but a click noise comes from under dash ..I hit start and it clicks six times and Or what needs to be done on my car to make the remote start work? Check This Out Your best bet is take it back to your installer and have them take a look at it.

Reply Mitch says April 26, 2012 at 6:20 pm I am not sure what this could be… Perhaps change the battery in the remote? Reply Mitch says November 25, 2012 at 6:30 pm Joe, We do not sell or install that brand. AAA came out and tested the battery and the battery is fine. May have inadvertently cut a wire.

We currently manufacture two types of remotes: 1-way communication and 2-way communication. 1-way remotes are the kind of remotes most of us are used to. If this applies to you, the good news is that, most of the time, one of these situations will apply to your vehicle. Any suggestions? In some cases, they may be able to tell you how to reprogram it over the phone.

Reply Victor says February 12, 2012 at 7:27 pm Hi, I got a compustar 2 way remote start. Further explanation of these zones is available in your owner’s manual. A couple of thoughts. 1. Reply Mitch says March 19, 2012 at 6:24 pm Very odd.